ROBOTRAX® System | Design principle
Mounting kit
Fast movements of the robot arms generate high accelerations and therefore high tensile forces on the cable carrier. To transfer these tensile forces, ROBOTRAX® has a hole at the center of each chain link through which the steel cable is pulled. This steel cable takes on the function of force transmission. The steel cable is fixed with a clamping piece on one side. ROBOTRAX® permits accelerations up to 10 g. The clamping piece can be used to easily set the chain links to the desired tension and adjust them at any time. Long service life of the cables and hoses: The forces are primarily transmitted by the cable carrier and not by cables and hoses. The mounting set consists of steel cable, clamping and tension piece for up to 5 m cable carrier length.
Quick-release brackets
The ROBOTRAX® is fixed and continued with quick- release brackets which are attached with screws. The quick-release brackets fit on any chain link of the respective size. This means the fixing points can be individually adjusted to the motion sequence. Locking bolt: 100% recyclable, cost-effective locking bolt, optimized for installation space and environment. The bolt can be assembled and disassembled without tools. (Also available as a screwed version)
Dimensions
R140X
h 1
R040 R056 R075 R085 R100 R140X 5470 86105120164 15 22 28 30 32 50 82 86 110 133 150 197.4 50 63 82 96112 158 36 48 64 72 70 70 18 24 32 36 35 35 – – – – – 20
R040 – R100
h 1
h 1 [mm] l 1 [mm] l 2 [mm] b 1 [mm] b 2 [mm] b 3 [mm] b 4 [mm] b 5 [mm] Screws
b 2
b 2
b 1
b 1
l1
–
–
–
–
– 32
l 2
b 4
b 5 b 3
2 x M4 2 x M4 2 x M6 2 x M8 2 x M8 4 x M8
b 3
Powered by FlippingBook