Configuration guidelines | Installation options
For the configuration of this installation options we recommend the simple way of determining the cable carrier length using our Configurator at onlineengineer.de or requesting support from our support team.
Opposed arrangement with lowered drive connection and reverse bending radius
L Z1
L S
If the cable carrier is wider than the available space due to a very large number of cables, a second cable carrier can be used, running in the opposite direction. This almost halves the total width because the cables can be distributed among both cable carriers.
U B
L S /2
L Z1
RKR
Moving bracket
RKR
l 1
X
L B
KR
H
L KA ´
Fixed bracket
X
L KA
The cable carrier length is then determined in the same way as for single-sided arrangements. For only one moving consuming unit and a joint travel path, both cable carrier lengths have to be the same. As both cable carriers run in a guide channel, it must be ensured that they have the same outer width. More information and the details for dimensioning the guide channel can be found in chapter Support trays and guide channels on page 692.
INV 4 Vertical arrangement, hanging
Direction of movement: only vertical
Direction of movement: vertical/horizontal combined For a combined vertical/hori- zontal movement process, the cable carrier can be mounted without special lateral support.
Direction of movement: only vertical
For a purely vertical movement process, the cable carrier can be mounted without special lateral support.
If the entire system moves at a right angle to and/or alongside the hanging cable carrier, an additional lateral guide has to be mounted.
Please observe the guidelines for placement of cables in cable carriers from TSUBAKI KABELSCHLEPP, s. page 70. It is practical to install the cable carrier without or with only little pretension . As no direct load occurs in the hanging arrangement, pretension causes the cable carrier to bulge outwards from the pretension. In addition to the visual aspect, this significantly increases the installation dimensions. The cables have to be fixed to the drive bracket and mounting bracket in such a way that their weight and the resulting dynamic load are absorbed only be the strain relief. Determining the cable carrier length see page 65.
79
Powered by FlippingBook